Uporabniški priročnik za enoto M5STACK C6L Inteligentno robno računalništvo
Unit C6L is an intelligent edge computing unit integrated with the M5Stack_Lora_C6module — featuring an Espressif ESP32-C6 SoC and Semtech SX1262 LoRa transceiver — and engineered with a modular design for long-range, low-power LoRaWAN communication alongside high-speed 2.4 GHz Wi-Fi and BLE connectivity.
It includes a 0.66″ SPI OLED display for real-time data visualization, a WS2812Caddressable RGB LED for system-status indication, a built-in buzzer for audible alerts, and front-panel buttons (SYS_SW) with a reset switch for local interaction. Astandard Grove I²C interface allows seamless integration with M5Stack hosts and various Grove sensors. The onboard USB Type-C port supports ESP32- C6 firmware programming, serial debugging, and 5 V power input, while automatic power switching and multi-channel ESD/surge protection ensure stable operation. Unit C6L excels at real-time data acquisition, edge-intelligence processing, and remote control, making it ideal for IoT applications such as smart agriculture, environmental monitoring, industrial IoT, smart buildings, asset tracking, and urban infrastructure sensing.\
1.1. Enota C6L
- Komunikacijske zmogljivosti
Integrated LoRa (Semtech SX1262), supporting LoRaWAN Class A/B/Candpointto-point modes 2.4 GHz Wi-Fi and BLE via ESP32-C6-MINI-1U - Procesor in zmogljivost
Main Controller: Espressif ESP32-C6 (single-core RISC-V, up to 40 MHz) On-chip Memory: 512 KB SRAM with integrated ROM - Upravljanje z energijo in močjo
Power Input: USB Type-C (5 V input) and Grove 5 V input - Zaslon & Indikatorji
0.66″ SPI OLED display for real-time data visualization and status monitoringWS2812C addressable RGB LED for system-status indication Built-in buzzer for audible alerts - Interfaces & Controls
Grove I²C interface (with 5 V power) for seamless connection to M5Stack hostsandGrove sensors USB Type-C port for firmware programming, serial debugging, and power input Front-panel buttons (SYS_SW) and reset switch (MCU_RST) for local control - Expansion & Debug Pads
Bootloader pad: predefined jumper pad for entering bootloader mode Test points (TP1–TP8) for signal probing and in-circuit debug
2. SPECIFIKACIJE
| Parameter | Specifikacija |
| MCU | Espressif ESP32-C6 (enojedrni RISC-V, do 40 MHz) |
| Komunikacija | LoRaWAN; 2.4 GHz Wi-Fi BLE |
| Vhodna moč | USB tipa C (5 V) in Grove 5 V |
| Dobava Voltage | 3.3 V (vgrajeni LDO) |
| Flash shramba | 16 MB SPI Flash (128 Mbit) |
| Zaslon | 0.66”SPI OLED(128×64) |
| Indikator | Naslovljiva RGB LED dioda WS2812C |
| Brenčalo | Vgrajeni zvočni signal |
| Gumbi | System button (SYS_SW)and reset button(MCU_RST) |
| Vmesniki | Grove I²C; USB Type-C; ploščica za zagonski nalagalnik; ploščice za odpravljanje napak TP1-TP8 |
| Antene | 2×SSMB-JEF clamp priključki; 2× antenski priključki IPEX-4 |
| Delovna temperatura | Delovna temperatura |
| Dodatne funkcije | Multi-channel ESD/surge protection |
| Proizvajalec | M5Stack Technology Co., Ltd Block A10, Expo Bay South Coast, Fuhai Street, Bao’an District, Shenzhen, China |
| Frekvenčno območje za CE | 2.4G Wi-Fi: 2412-2472MHz BLE: 2402-2480MHz Lora: 868-868.6MHz |
| Največja EIRP za CE | BLE: 5.03dBm 2.4G Wi-Fi: 16.96dBm Lora: 9.45dBm |
| Kategorija sprejemnika | The equipment provider declared that the receiver category for the EUTis2. |
3. Opozorilo FCC
Opozorilo FCC:
Vse spremembe ali modifikacije, ki jih ni izrecno odobrila stranka, odgovorna za skladnost, lahko razveljavijo uporabnikovo pooblastilo za uporabo opreme. Ta naprava je skladna s 15. delom pravil FCC. Delovanje je odvisno od naslednjih dveh pogojev: (1) Ta naprava ne sme povzročati škodljivih motenj in (2) ta naprava mora sprejeti vse prejete motnje, vključno z motnjami, ki lahko povzročijo neželeno delovanje.
POMEMBNA OPOMBA:
Opomba: This equipment has been tested and found to comply with the limits for a ClassBdigital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
odpravite motnje z enim ali več naslednjimi ukrepi:
- Preusmerite ali premaknite sprejemno anteno.
- Increase the separation betweentheequipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. — Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator&your body.
I. Installing Arduino IDE(https://www.arduino.cc/en/Main/Software)
Kliknite za obisk uradnika Arduino webin izberite namestitveni paket za vašo
operating system to download. Ⅱ. Installing Arduino Board Management
1. Upravni odbor URL is used to index the development board information for specific platform. In the Arduino IDE menu, select File -> Nastavitve
2. Kopirajte upravljanje plošče ESP URL spodaj v dodatnega upravitelja odbora
URLs: field, and save.
https://espressif.github.io/arduino-esp32/package_esp32_dev_index.json
3. V stranski vrstici izberite Board Manager, poiščite ESP in kliknite Install.
4. V stranski vrstici izberite Upravitelj plošč, poiščite M5Stack in kliknite Namesti.
Depending on the product used, select the corresponding development board under
Tools -> Board -> M5Stack -> {ESP32C6 DEV Module board}.
5. Povežite napravo z računalnikom s podatkovnim kablom, da naložite program
Dokumenti / Viri
 |
Enota M5STACK C6L Inteligentna enota za robno računalništvo [pdf] Priročnik za lastnika M5UNITC6L, 2AN3WM5UNITC6L, Enota C6L Inteligentna enota za robno računalništvo, Enota C6L, Inteligentna enota za robno računalništvo, Enota za robno računalništvo, Računalniška enota, Enota |