TRACEABLE® ™ GIANT-DIGITS
ATOMIC CLOCK WITH INDOOR & OUTDOOR
TEMPERATURE INSTRUCTIONS
IZDELKA KONECVIEW
Glavna enota
- Gumb [ TIME SET ].
- [ +/CHANNEL ] button
- [ -/ MEM ] button
- [ SNOOZE ] button
- [ ALARM SET ] button
- Wall-mounting hole Thank you for purchasing this
- < °C/°F > slide switch
- [ SENSOR ] button
- [ RCC ] button
- Gumb [ RESET ].
- Namizno stojalo
- Vrata za baterije
Daljinski senzor
- LED indikator
- LCD
- Odprtina za pritrditev na steno
- Gumb [ RESET ].
- Predal za baterije
- [ CHANNEL 1/2/3 ] slide switch
Zaslon
Običajni časovni način
- AM/PM (12 Hour format)
- Čas
- Zunanja vlažnost
- Indikator signala senzorja
- Kazalnik vremenske napovedi
- Indikator prazne baterije za senzor
- Notranja vlažnost
- Notranja temperatura
- Indikator MAX/MIN
- Zunanja temperatura
- Ice Alert on
- RC indikator jakosti signala
- poletni čas
- Time zone indicator (WWVB only)
Način časa alarma
- Čas alarma
- Alarm icon/Alarm on
- Alarm mode indicator
- Renove the battery door of the clock and sensor.
- Insert 4 new AA size batteries to the clock, and 2 to the sensor according to the “+/-” polarity mark on the battery compartment.
- Zamenjajte vratca baterije.
- Once the batteries are inserted, full segment of the LCD will be shown.
- Press [RESET] button of main unit first, and press [RESET] button of transmitter.
- It will automatically receive 433 MHz signal from transmitter for the channel test in 8 seconds.
- After 5 minutes channel test, it will turn to RC signal reception automatically
- The RC clock will automatically start scanning for the radio controlled time
OPOMBA:
In some cases, you may not receive the signal immediately due to the atmospheric disturbance, the best reception often occurs during nighttime.
HOW TO PAIR MAIN UNIT AND SENSOR
- Press [+/CHANNEL] button on main unit to select a channel.
- On sensor, slide channel switch to corresponding channel. (For additional sensors, select a different channel). Press [RESET] button.
- Press [SENSOR] on main unit to initiate search for 433 MHz reception.
433 MHz WIRELESS SENSOR RECEPTION
If the main unit receives wireless sensor signal successfully, the signal icon displays. While if it cannot receive sensor signal or signal is lost, icon displays.
VARČEVANJE ČASA DNE LUČKE (DST)
The clock will automatically advance the time by one hour in the spring and back an hour in the fall. Your clock will display “DST” during summer.
SPREJEM RADIJSKO KONTROLIRANEGA SIGNALA
This RC clock includes a built-in receiver which picks up the signal from the DCF/MSF/WWVB station. Therefore, the clock automatically sets the time, date and weekday.
- The clock automatically carries out four periodic synchronization procedures (at 2:00 AM, 8:00 AM, 2:00 PM and 8:00 PM daily) with the RC signal to correct any deviations to the exact time.
- Once the unit synchronizes successfully to the RC signal, the signal icon” will show up. Each synchronization process will take between 6 to 16 minutes.
- To manually start or stop the RC signal reception, press [RCC] button or press and hold it for 3 seconds.
OPOMBA:
- Na moč radijsko nadzorovanega časovnega signala iz stolpa oddajnika lahko vpliva geografska lokacija ali okolica.
- Enote vedno namestite stran od motečih virov, kot so televizor, računalnik itd.
- Izogibajte se postavljanju enote na ali poleg kovinskih plošč.
- Zaprti prostori, kot so letališče, klet, stolpnica ali tovarna, niso priporočljivi.
KAZALNIK SPREJEMA SIGNALA
Kazalnik signala prikazuje moč signala v 4 nivojih. Utripajoči segment valov pomeni, da so sprejeti časovni signali. Kakovost signala lahko razvrstimo v 4 vrste:
RC synchronize process
Slaba kakovost signala
Sprejemljiva kakovost signala
Odlična kakovost signala
TIME ZONE SETTING (WWVB VERSION ONLY)
Your clock is designed to display time for different time zones. Please refer to the SETTING THE TIME AND CALENDAR section to set your desired time zone in following order:
PST (Pacific) (Mountain) (Central) (Eastern)
NASTAVITEV ČASA IN KOLEDARJA
- In normal time mode, press and hold [ TIME SET] button for 3 seconds until the 12/24 Hr flashes.
- Press [+/CHANNEL ]/[ -/ MEM] button to set 12/24 Hour format.
- Press [ TIME SET] button again until Hour digit flashes and press [+/CHANNEL ]/[ -/ MEM] button to adjust its value.
- Repeat above operations to set the time and calendar in this sequence:
- DCF/MSF version: 12/24Hr>Hour>Minute>Second>+/-23 Hour offset WWVB version: 12/24Hr>Hour>Minute>Second>Time Zone
- Press [TIME SET] button to save the setting and return to normal time mode. Or the clock will automatically exit the setting mode after 1 minute without pressing any button.
OPOMBA:
When setting second, press [+/CHANNEL]/[ -/ MEM] button to set its value to 00.
NASTAVITEV ČASA ALARMA
- In normal time mode, press [ ALARM SET] button to enter alarm time mode. Press and hold [ALARM SET] button for 3 seconds until Hour digit flashes.
- Press [+/CHANNEL ]/[ -/ MEM] button to set its value.
- Press [ALARM SET ] button again to step to Minute setting. Press [+/CHANNEL ][ -/ MEM] button to set its value.
- Press [ ALARM SET ] button to save the setting and return to normal time mode. Or the clock will automatically exit the setting mode after 1 minute without pressing any button.
OPOMBA:
After pressing [+/CHANNEL ]/[ -/ MEM] button, alarm function is automatically turned on (icon “
« prikazano).
UPORABA ALARMA IN DREMEŽA
- In normal time mode, press [ ALARM SET] button to enter alarm time mode.
Press [ ALARM SET] button again to turn on (icon “A” displayed) or turn off alarm function.
If alarm is turned on, alarm beeps at the alarm time.
Alarm beeping can be stopped by: - Auto stop if no button is pressed during alarm sound beeping. Alarm beeping lasts for 2 minutes.
- Press [ SNOOZE] button to stop the current alarm and enter snooze. Alarm icon will be flashing continuously. The alarm will sound again in 5 minutes.
Snooze can be operated continuously in 24 hours. - Press [ ALARM SET] button to turn off alarm function.
TEMPERATURA IN VLAGA
To Select Temperature Unit
Slide [°C/°F] switch on main unit to <°C> or <°F> position.
To Read Outdoor Temperature and Humidity
The default displayed channel is channel 1.
- In normal mode, press [+/CHANNEL] button repeatedly to view readings of channel 1, 2 and 3.
- Press and hold [ +/CHANNEL] button for 2 seconds to enter channel auto-change, and channels change automatically in every 4 seconds.
- Press [+/CHANNEL] again to return to normal mode.
OPOMBA:
- Once the channel is assigned to one sensor, you can only change it by removing the batteries or resetting the unit.
- If no signals are received or the transmission is interfered, “–” will appear on the LCD.
- Relocate the main unit and sensor in other positions and make sure the transmission is within the effective range of 50 meters approx.
- After several trials in vain, please reset the main unit thoroughly. Try out where your multifunctional main unit receives the signals best.
VIEWING MAXIMUM AND MINIMUM RECORDS
- Press [ -/ MEM ] button to review maximum and minimum indoor & outdoor temperature and humidity records. forecast in next 12 to 24 hours.
- Medtem ko ponovnoviewing the maximum and minimum records, press and hold [ -/ MEM] button for 3 seconds to clear both max & min records.
OPOMBA:
- Record value will be updated by new higher or low record.
- Once you re-insert batteries to the main unit, all of the value will be defaulted.
OPOMBA:
- Natančnost splošne vremenske napovedi, ki temelji na tlaku, je približno 70% do 75%.
- Vremenska napoved je predvidena za naslednjih 12 ~ 24 ur, morda ni nujno, da odraža trenutno stanje.
VREMENSKA NAPOVED
This main unit contains built-in sensitive pressure sensor to predict weather forecast in next 12 to 24 hours
OPOMBA:
- Natančnost splošne vremenske napovedi, ki temelji na tlaku, je približno 70% do 75%.
- Vremenska napoved je predvidena za naslednjih 12 ~ 24 ur, morda ni nujno, da odraža trenutno stanje.
OPOZORILO ZA LED
When the outdoor temperature falls between -2°C to 3°C (28°F to 37°F), the ice alert icon will display on the LCD and flash continuously, and disappear once the temperature is out of this range.
When the LCD becomes dim, replace with 4 AA sithe low battery indicator “ ” displays in the outdosize batteries to the sensor at once.
SPECIFIKACIJE
| Radio Controlled signal: | WWVB |
| RF oddajna frekvenca: | 433 MHz |
| Razpon RF prenosa: | Največ 50 metrov |
| No. of remote sensor: | Do 3 enot |
| Cikel zaznavanja temperature: | Around 60~64seconds |
NOTRANJA TEMPERATURA
| Prikazani obseg: | -40°C ~ 70°C (-40°F ~ 158°F) |
| Območje delovanja: | 0°C ~ 45°C (32°F ~ 113°F) |
| Natančnost: | -20°C ~ 0°C: +/- 2°C (+/- 4.0°F) 0°C ~ 40°C: +/- 1°C (+/- 2.0°F) 40°C ~ 60°C: +/- 2°C (+/- 4.0°F) |
NOTRANJA VLAŽNOST
| Prikazani obseg: | 1 % ~ 99 % |
| Območje delovanja: | 20 % ~ 90 % |
| Resolucija: | 1% |
| Natančnost: | 20% ~ 39%: +/- 8% @ 25°C 40% ~ 70%: +/- 5% @ 25°C 71% ~ 90%: +/- 8% @ 25°C |
ZUNANJA TEMPERATURA
| Prikazani obseg: | -40°C ~ 70°C (-40°F ~ 158°F) |
| Območje delovanja: | -20°C ~ 60°C (-4°F ~ 140°F) |
| Natančnost: | 0°C ~ 45°C (32°F ~ 113°F) -20°C ~ 0°C: +/- 2°C (+/- 4.0° -20°C ~ 0°C: +/- 2°C (+/- 4.0°F) 0°C ~ 40°C: +/- 1°C (+/- 2.0°F) 40°C ~ 60°C: +/- 2°C (+/- 4.0°F) 0°C ~ 40°C: +/- 1°C (+/- 2.0° |
VLAŽNOST NA PROSTEM
| Prikazani obseg: | 1 % ~ 99 % |
| Območje delovanja: | 20 % ~ 90 % |
| Resolucija | 1% |
| Natančnost: | 20% ~ 39%: +/- 8% @ 25°C 40% ~ 70%: +/- 5% @ 25°C 71% ~ 90%: +/- 8% @ 25°C |
GARANCIJA, SERVIS ALI PONOVNO UMERJANJE
Za garancijo, servis ali ponovno kalibracijo kontaktirajte:
Sledljivi izdelki
12554 Old Galveston Rd. Suita B230 Webster, Teksas 77598 ZDA
Št. 281 482-1714
Faks 281 482-9448
E-pošta support@traceable.com
www.traceable.com
Izsledljivi izdelki so v skladu s standardom ISO 9001: 2015
Certificirano z DNV in ISO/IEC 17025: 2017, akreditirano kot kalibracijski laboratorij pri A2LA.
Dokumenti / Viri
 |
GIANT-DIGITS 1087 Radio Atomic Traceable Clock with Remote Sensor [pdf] Uporabniški priročnik 1087, 1089, 00, 1087 Radio Atomic Traceable Clock with Remote Sensor, 1087, Radio Atomic Traceable Clock with Remote Sensor, Atomic Traceable Clock with Remote Sensor, Traceable Clock with Remote Sensor, Clock with Remote Sensor, with Remote Sensor, Remote Sensor |