Dickson WiZARD2 Replaceable Sensor Logger
Specifikacije
| Komponenta | Opis |
|---|---|
| Replaceable Sensor™ | Firmly plugs into the logger, ensuring proper contact. |
| Baterije | 4 C type batteries required for operation. |
| AC adapter | Used to power the unit along with batteries. |
Pomembno obvestilo
Please follow the steps below before using your chart recorder for the first time.
Set Chart
- Dvakrat pritisnite MENU.
- Use UP or DOWN buttons to scroll through available chart number options (chart options determined by attached sensor).
- Pritisnite MENU, da shranite.
- Default Unit of Measure will display. Use UP or DOWN buttons to scroll and select alternate (option may not display depending on chart selected).
- Pritisnite MENU, da shranite.
Nastavite čas
- Pritisnite MENU.
- ADJ TIME will display. Press and hold UP or DOWN button to rotate chart to the correct time or day/time as referenced by the timing arrow (just below the pen ramp).
- Pritisnite MENU, da shranite.
- Press HOME. Pens will move onto the chart to begin recording.
Delovanje
Za začetek delovanja
- Odstranite zaščitni pokrovček peresnika.
- Plug the Replaceable Sensor™ firmly into the logger (lower left side of case). Confirm the raised bump on the Replaceable Sensor touches the inside edge of the sensor compartment.
- Insert Batteries (4 C type) and plug into AC adapter.
- Install chart. Confirm the chart is aligned on the hub and slid underneath the pen home ramp and chart clip.
- Press the power button and follow the display prompts to configure. Opomba: Unit may power on automatically when AC and battery power are applied.
pogosta vprašanja
-
What should I do if the unit does not power on?\
Ensure that both the AC adapter is plugged in and the batteries are correctly installed.
Dokumenti / Viri
 |
Dickson WiZARD2 Replaceable Sensor Logger [pdf] Uporabniški priročnik WiZARD2 Replaceable Sensor Logger, WiZARD2, Replaceable Sensor Logger, Sensor Logger, Logger |