Uvod
Thank you for choosing the Sunco LED Wraparound Shop Light. This manual provides essential information for the safe installation, operation, and maintenance of your new lighting fixture. Please read these instructions thoroughly before installation and retain them for future reference.
Varnostne informacije
- OPOZORILO: Nevarnost električnega udara. Pred namestitvijo ali servisiranjem izklopite varovalko ali odklopnik.
- Ta izdelek mora v skladu z veljavnim kodeksom namestitve namestiti oseba, ki je seznanjena s konstrukcijo in delovanjem izdelka ter s temi nevarnostmi.
- Zagotovite dovodni voltage je združljiv z napeljavo (120–277 V).
- Ne dotikajte se žic pod napetostjo.
- Ne spreminjajte svetilke. Kakršne koli spremembe lahko razveljavijo garancijo in povzročijo varnostne nevarnosti.
- Primerno za damp lokacije.
Vsebina paketa
Pred začetkom namestitve preverite, ali so prisotne vse komponente:
- LED Wraparound Shop Light Fixture (2 units for 2-pack)
- Montažna oprema
- Linking Cables (for connecting multiple fixtures)
- Navodila za uporabo
Specifikacije
| Številka modela | SHW-40W-5K-2PK |
| Poraba energije | 40 vatov |
| Svetlobna moč | 3500 lumnov |
| Barvna temperatura | Dnevna svetloba 5000K |
| voltage | 120-277V |
| Dimenzije | 48 cm D x 5.35 cm Š x 2.36 cm V |
| Kot snopa | 110 stopinj |
| CRI | 80+ |
| Vrsta namestitve | Flush Mount / Hardwired |
| Posebne lastnosti | Prismatic Lens, Linkable (up to 8 units), Non-Dimmable |
| Certifikati | ETL |
Navodila za namestitev
This fixture is designed for direct surface mounting to the ceiling. Always ensure power is disconnected before starting installation.
- Pripravite pritrditev: Carefully remove the diffuser (Part B) from the lamp base (Part A) to access the wiring and mounting points.
- Namestite napeljavo: Postavite lamp base against the ceiling where you intend to install it. Mark the mounting holes. Use appropriate mounting hardware (screws, anchors) to securely attach the lamp base to the ceiling.
- Ožičenje: Bring the electrical supply wires from the junction box to the fixture. Connect the wires according to local electrical codes: Black to Black (Live), White to White (Neutral), Green/Bare Copper to Green (Ground). Ensure all connections are secure with wire nuts.
- Replace Diffuser: Once wiring is complete and secure, carefully reattach the diffuser to the lamp base. Ensure it snaps firmly into place along both sides.
Povezovanje več vpenjal
These fixtures are linkable, allowing you to connect up to 8 units from a single power source. Use the provided linking cables or flush linking connectors to connect fixtures end-to-end. Ensure the total wattage povezanih napeljav ne presega zmogljivosti vezja.
Delovanje
Once properly installed and powered, the Sunco LED Wraparound Shop Light will provide instant-on, flicker-free illumination. This fixture is non-dimmable and operates at a 5000K Daylight color temperature, designed to mimic natural daylight for enhanced visibility and alertness.
Vzdrževanje
The Sunco LED Wraparound Shop Light is designed for long-lasting performance with minimal maintenance. The integrated LED design means there are no bulbs to replace.
- Čiščenje: Ensure power is off before cleaning. Wipe the fixture and diffuser with a soft, damp cloth. Do not use abrasive cleaners or solvents, as these may damage the finish or optical components.
- Pregled: Periodically inspect the fixture for any signs of damage or loose connections. If any issues are found, disconnect power and contact a qualified electrician or Sunco Lighting support.
Odpravljanje težav
If you experience issues with your Sunco LED Wraparound Shop Light, refer to the following common problems and solutions:
| Težava | Možen vzrok | rešitev |
|---|---|---|
| Lučka se ne prižge | Ni napajanja; Ohlapna ožičenje; Okvarjena napeljava. | Check circuit breaker/fuse. Ensure all wire connections are secure. If problem persists, contact Sunco support. |
| Svetloba je šibka ali utripa | Incompatible dimmer switch (fixture is non-dimmable); Loose wiring; Power fluctuation; Fixture nearing end of life. | Ensure no dimmer switch is used. Check wiring connections. If dimming occurs after extended use (e.g., 1.5-2 years), it may indicate a component issue. Contact Sunco support for warranty assistance. |
| Only some linked lights are working | Loose linking cable connection; Faulty individual fixture in the chain. | Check all linking cable connections. Isolate the non-working fixture to determine if it's an individual unit issue. |
If troubleshooting steps do not resolve the issue, please contact Sunco Lighting customer support.
Garancija in podpora
Sunco Lighting stands behind the quality of its products. This LED Wraparound Shop Light comes with a 7-letna zaščita warranty. For warranty claims, technical assistance, or any questions regarding your product, please contact our knowledgeable support specialists.
Kontaktni podatki: Please refer to the Sunco Lighting webNajnovejše kontaktne podatke najdete na spletnem mestu ali v dokumentaciji o nakupu.
