Leviton 003-84026-0 Stainless Steel 2-Gang Power Outlet Receptacle Wallplate Instruction Manual

Uvod

This manual provides instructions for the proper installation and maintenance of the Leviton 003-84026-0 Stainless Steel 2-Gang Power Outlet Receptacle Wallplate. Please read these instructions carefully before beginning installation.

Varnostne informacije

• Always turn off power at the circuit breaker or fuse box before installation or maintenance.
• Prepričajte se, da so vse električne povezave skladne z lokalnimi električnimi predpisi.
• Če niste prepričani glede katerega koli dela teh navodil, se posvetujte s kvalificiranim električarjem.
• Ta izdelek je zasnovan samo za uporabo v zaprtih prostorih.

Vsebina paketa

• Leviton 003-84026-0 Stainless Steel 2-Gang Wallplate
• Mounting Screws (typically included with wallplate)

Nastavitev in namestitev

1. Izklopite napajanje: Locate the circuit breaker or fuse that controls the power to the outlet where the wallplate will be installed. Turn off the power completely. Verify power is off using a voltage tester.
2. Remove Old Wallplate: Carefully unscrew and remove the existing wallplate, if any.
3. Position New Wallplate: Align the Leviton 003-84026-0 wallplate over the electrical box, ensuring the openings match the receptacles.
4. Secure Wallplate: Insert the provided mounting screws into the designated holes on the wallplate and tighten them gently until the wallplate is flush with the wall. Do not overtighten, as this can damage the wallplate or the electrical box.
5. Obnovi moč: Once the wallplate is securely installed, restore power at the circuit breaker or fuse box.

Navodila za uporabo

The Leviton 003-84026-0 wallplate is a passive component designed to cover and protect electrical outlets. No specific operational steps are required beyond its proper installation. Ensure that the receptacles are fully accessible and that the wallplate does not obstruct their use.

Vzdrževanje

• Čiščenje: To clean the stainless steel wallplate, use a soft, damp cloth. For stubborn marks, a mild, non-abrasive cleaner suitable for stainless steel can be used. Avoid harsh chemicals or abrasive scrubbers, which can scratch the finish.
• Pregled: Periodically inspect the wallplate for any signs of damage, such as cracks, discoloration, or loose screws. If damage is observed, turn off power and replace the wallplate.

Odpravljanje težav

• Wallplate is Loose: Ensure mounting screws are tightened appropriately. Do not overtighten.
• Wallplate Does Not Sit Flush: Check for obstructions behind the wallplate or ensure the electrical box is properly recessed.
• Praske ali razbarvanje: Refer to the Maintenance section for cleaning instructions. Deep scratches may require replacement.

Specifikacije

This diagram illustrates the precise dimensions of the 2-gang wallplate. It shows a width of 2.750 inches (69.85 mm) for each opening, a total width of 4.56 inches (115.9 mm) for the 2-gang configuration, and a height of 4.500 inches (114.30 mm). The thickness is 0.220 inches (5.59 mm). Screw hole spacing and opening dimensions are also detailed.

Informacije o garanciji

Leviton products are backed by a limited warranty. For specific warranty terms and conditions, please refer to the official Leviton webspletno mesto ali se obrnite na podporo strankam. Shranite dokazilo o nakupu za uveljavljanje garancije.

Podpora in kontakt

For technical assistance, product inquiries, or support, please visit the official Leviton webspletno mesto ali se obrnite na njihov oddelek za pomoč strankam. Kontaktne podatke običajno najdete na proizvajalčevi strani webembalaža spletnega mesta ali izdelka.

• Proizvajalec: Leviton
• Webspletno mesto: www.leviton.com