Android Car Player Instruction Manual

Android Car Player Instruction

SPECIFIKACIJA

• power Supply Volllgo
• Največja trenutna poraba
• Največja izhodna moč

1. SHEMA OŽIČENJA UNIVERZALNEGA STROJA
   
2. SHEMA OŽIČENJA ZA POSEBNA VOZILA

PREVIDNOSTNI UKREPI ZA OŽIČEVANJE

• 10P: Connect the reversing video input. Note: The two short wires above this line are the Bluetooth antenna and the WIFI antenna. Even if the reversing camera is not connected, this cable needs to be connected to the machine, otherwise Bluetooth and WIFI will not be connected, and carplay and Android auto will not be connected.
• 6P: Priključite USB-2.
• 4P. Connect USB-1.
• 8P: Connect the CANBUS box. Note: When the product you purchased has a CANBUS box, you must connect the CANBUS box to the
• 8Pin socket on the body, otherwise some of the original car functions will not be available.
• 12P.360-degree panoramic reversing image (only supported by some models).
• 20P.RCA plug. The AMP Pri liniji CONT bodite pozorni na: Če vaš avtomobil podpira zvočnike, kot sta JBL ali BOSE, boste morda morali ta kabel priključiti na vklopno/izklopno stikalo napajanja vašega avtomobila. amplifier, and try connecting it when there is no sound.

NAČIN NAMESTITEV KAMERE ZA VZVRATNO POZIVANJE

NAVODILA ZA OŽIČENJE UNIVERZALNEGA NAPAJALNEGA KABLA

Tips The wiring harness colors of some models may be different. Please refer to the wire labels and the positions on the plugs and sockets.

DEFINICIJA PINOV ZA NAPAJANJE UNIVERZALNEGA STROJA

UČENJE KONTROL ZA VOLANOM
Pritisnite in držite gumb na volanu originalnega avtomobila in poiščite ikono gumba, ki ustreza funkciji gumba na volanu. Kliknite ikono za spremembo barve, učenje je uspešno.

iPhone Mirrorlink (podpira samo nekatere modele)
Ko je naprava priključena na iPhone, se vsebina zaslona telefona projicira na zaslon avtomobila.

Android Mirrorlink (podpirajo samo nekateri modeli)
When using an Android device, after connecting the USB data cable. you will be prompted to install the APP software. After installation, Plug the data cable again, it will enter the screen mirroring mode. And it can be operatedon both the player screen and the phone screen. Only the image transfer is successful at this time. The sound can only be  transmitted after the Bluetooth connection is successful.

Apple Car Play (Only some models support)

1. Wired connection: Just connect the USB data cable, and then it will auto matically enter the CarPlay interface.
2. Wireless connection: first tum on the bluetooth and wifi functions of the mobile phone. and then connect the bluetooth. Then it will automatically enter the CarPlay interface.
   (Note. The signal is transmitted through wifi at this ime, so even if the Bluetooth function is tumed off, it will be transmitted normally. When the wifi function is turned off. CarPlay will be disconnected.)

Android Auto (podpira samo nekatere modele)
Ta funkcija ni podprta v vseh državah in »storitve Google Play morajo biti na voljo lokalno.

1. Prenesti in namestiti morate »Android Auto« software in “Google Play”
2. Uporabiti je treba mobilni telefon s sistemom Android 6.0 ali novejšim. Uporabiti morate veljavno podatkovno kabelsko povezavo.
3. Žična povezava: Samo povežite podatkovni kabel USB in samodejno vstopi v vmesnik Android Auto.
4. Wireless connection: First turn on the Bluetooth and wifi functions of the mobile phone. and then connect the Bluetooth. Then it will automatically enter the Android Auto interface. (Note: The signal is transmitted through wifi at this time, so even if the Bluetooth function is turned off, it will be transmitted normally. When the wifi function is turned off, Android Auto will be disconnected.)

POGOSTE TEŽAVE IN PREPROSTO ODPRAVLJANJE TEŽAV

Ni mogoče normalno zagnati

1. “Yellow” “Red” “Black’ this 3 lines only connected 2 line of them, so it will not start, it should be that the yellow line is connected to the positive pole, red line to the key control line, black to the negative pole, less connection or wrong connection does not boot.
2. Prvotne linije avtomobila in ožičenja enote ni mogoče povezati z barvo, barva originalne linije avtomobila ni standardna, če tako povežete, se ne more samo vklopiti, ampak lahko tudi zagori.
3. Originalnega avtomobilskega vtiča ni mogoče priključiti neposredno v novo enoto, tudi če se le vtakne, ga ni mogoče uporabiti. sicer se ne bo vklopil ali zažgal.
4. 3 žice so pravilno povezane, vendar se ne zažene. Preverite, ali je varovalka na rumeni črti pokvarjena. Če z varovalko ni težav, zvijte rumeno in rdečo žico skupaj. Vklopite ključ in pritisnite gumb za vklop enote, da preverite, ali ga je mogoče vklopiti.
5. Every time you change the fuse, it burns. Please don’t change it again The reason is that when you first connect the positive and negative poles, the protection circuit of the unit is short-circuited. The unit can be repairedunder the guidance of our master. No basis can only be returned to the after-sales or new unit. If these are no problem, or also don’t boot, please make the final step to confirm, find a 12V battery or 12V power supply yellow and “red twist together with the positive, black to the negative pole. press the button check if it can boot or no, if you can boot, it showed that the original car line is not right connect, or there is a problem with the car line.  If it can’t be boot, the unit is broken. Does not boot unit, check the line carefully, do not blindly suspect the unit problem.

Samodejni izklop

1. Napaka povezave kabla: Če je modri kabel (samodejno napajanje antene) priključen na napajalni kabel enote, bo prišlo do samodejnega izklopa. Upoštevajte pravilen način ožičenja, da odpravite težavo.
2. Voltage je nestabilen: prosimo, poiščite 12V-5A, kateri je napajalnik, in ga ponovno preizkusite, da vidite, ali se bo samodejno izklopil. Če se po preizkusu ne izklopi samodejno, zamenjajte napajalnik. Če se samodejno izklopi, je težava z enoto.

Čuti se hrup

1. Prvotna moč zvočnika je premajhna. Ko je glasnost enote povečana. hrup bo.
   rešitev: Ko zamenjate zvočnik ali poslušate skladbo, glasnost ne sme biti prevelika.

Kabel zvočnika je ozemljen.
rešitev: Vzemite železni zvočniški kabel. Neposredno priključen na zvočniški kabel enote.

Daljinskega upravljalnika ni mogoče uporabiti

1. Test method Turn on the camera of the mobile phone and align the light of the remote control then press the button of the remote control to see if the phone will light up. If it is not lit there will be no power. Replace the battery: If it is it there is electricity, which proves that there is no problem with the remote control.

Nastavitev ni mogoče shraniti (ni pomnilnika)

1. Rumena črta in rdeča črta sta povezani skupaj (ločeno rumeno na pozitivno, rdečo na ključno krmiljenje).
2. Rumena in rdeča sta obrnjeni (samo spremenite položaj).

Bluetooth ne deluje
Vklopite napravo, poiščite ime Bluetooth naprave z Bluetooth mobilnega telefona in nato kliknite Poveži, ko se povežete, lahko sprejemate klice ali predvajate pesmi prek povezave Bluetooth.

Izdelek oddaja dim
Zamenjajte varovalko FUSE, če težave ni mogoče rešiti, je notranji tokokrog pregorel. Potrebne so poprodajne storitve.

Zvoka ni mogoče prilagoditi

1. Ponastavite enoto ali izvlecite napajalni kabel in ga priključite.
2. The Volume knob is broken, and it can be replaced.

Kamera za vzvratno vožnjo ne prikazuje slike

1. Napačno ožičenje ali manjkajoče ožičenje.

Način povezave kamere:

1. Poiščite dodatno opremo: 1 kamera + 1 napajalni kabel + 1 video kabel.
2. Find the port of the wiring. First find the reverse control line on the power line of the unit. The control line is a pink line. Connect this line to the positive pole of 12V and the screen will turn blue. And then find the back of the unit the CAM video input interface, find the positive and negative of the backup light.
3. Na kameri sta dve vtičnici, rdeča vtičnica je priključena na napajalni kabel, rumena je vstavljena v video kabel, rdeča žica napajalnega kabla in žica video kabla sta priviti skupaj na pozitivni pol obratno lamp, and the black wire of the power cable is not used. connected, the other end of the video cable is connected to the CAM video input interface on the back of the unit. The red line coming out of the video line is connected to the reversing control line of the power line.
4. Kamera je pokvarjena. Če je lamp ki je pravilno priključena na kamero, ne sveti. bo pokvarjen in zamenjan z novim.

Naprav USB ni mogoče predvajati
Formatirajte bliskovni disk USB in file sistem je izbran kot: FAT32, ponovno prenesite eno ali dve skladbi in poskusite znova. Če še vedno ne deluje, zamenjajte bliskovni pogon USB.

FM ne sprejema radijske postaje

1. The antenna plug is not fully inserted, the antenna is disconnect or the line is disconnected.
2. Search station, press AS will automatically search or press the before or after button. Can’t solve the above 2 points. Please unplug the antenna plug and find a screwdriver or a metal strip to insert into the antenna.

Takoj po namestitvi ni zvoka
Dear customers, the unit has been tested before shipment. If there is no sound, it is usually a wiring error or the original car speaker wire is short- circuited with iron. According to the steps to check it:

1. Preverite, ali je kabel zvočnika v kratkem stiku in ali je priključen. Če pride do kratkega stika, ponovno priklopite.
2. Check how many speaker cables according to the original speaker cable if there are only 2 speaker cables, to prove that the original car line does not match our unit, you need to re-route the original car line. One speaker must lead to 2 speaker wires. 2 speakers must be have 4 speaker cables to available.

Čez nekaj časa ni zvoka
Disconnect all the speaker cable from the unit (do not remove them), and then find an external speaker to receive the gray and purple of the tail line of the unit.Check any group, and then try to see if there is any sound If there is a sound, it is proven that the car’s speaker line is short-circuited with iron or the speaker is damaged. If there is no sound, the unit is broken.

Nasveti: If the device is updated, the functions are subject to change without prior notice