Atlanta Digital Radio-Controlled LCD Alarm Clock

Uvod

Thank you for choosing the Atlanta 1879-7 Digital Radio-Controlled LCD Alarm Clock. This device offers precise timekeeping through radio signal synchronization, multiple alarm functions, and a convenient backlight. This manual provides detailed instructions for setup, operation, and maintenance to ensure optimal performance.

Varnostna navodila

• Naprave ne izpostavljajte ekstremnim temperaturam, neposredni sončni svetlobi ali visoki vlažnosti.
• Pazite, da vam ura ne pade ali da je ne izpostavljate močnim udarcem.
• Use only the specified battery type (2 x AA). Ensure correct polarity during installation.
• Če ure ne boste uporabljali dlje časa, odstranite baterije, da preprečite puščanje.
• Hraniti izven dosega otrok.

Vsebina paketa

• Atlanta 1879-7 Digital Radio-Controlled LCD Alarm Clock
• Uporabniški priročnik

Note: 2 x AA batteries are required and not included.

Nastavitev

1. Namestitev baterije

The clock operates on 2 x AA batteries. To install:

1. Poiščite pokrovček predalčka za baterije na zadnji strani ure.
2. Potisnite pokrov navzdol, da ga odprete.
3. Insert two AA batteries, observing the correct polarity (+/-) as indicated inside the compartment.
4. Ponovno namestite pokrov prostora za baterije.

Slika: Nazaj view of the alarm clock with the battery compartment and control buttons. The battery compartment is located on the right side of the back panel.

2. Initial Power-On and Radio Signal Synchronization

Upon battery installation, the clock will automatically attempt to synchronize with the DCF radio signal. This process may take several minutes. During synchronization, a radio signal icon will typically flash on the display. Once synchronized, the icon will become solid, and the correct time and date will be displayed.

• Za boljši sprejem signala postavite uro blizu okna.
• Izogibajte se postavljanju v bližino elektronskih naprav, ki lahko povzročajo motnje.

3. Nastavitev časovnega pasu

If you are in a different time zone than the default DCF signal (Central European Time), you can adjust the time zone offset:

• Refer to the control buttons on the back or side of the clock.
• Press the designated 'TIME ZONE' or 'SET' button (refer to button diagram below) to enter time zone adjustment mode.
• Use the '+' or '-' buttons to set the desired offset in hours.
• Confirm your selection by pressing the 'SET' button again or waiting for the setting to auto-confirm.

Slika: Stran view of the alarm clock, highlighting the three control buttons on the left side panel.

Navodila za uporabo

1. Prikaz čezview

The LCD display shows the current time, date, day of the week, and alarm status.

Image: Front display of the alarm clock, showing the time (13:32), date (25/4), and day of the week (MON) clearly visible.

2. Setting Alarms (3 Separate Alarms)

This clock features three independent alarms. To set an alarm:

1. Press the 'ALARM' button (often labeled with a bell icon) repeatedly to cycle through Alarm 1, Alarm 2, and Alarm 3 settings.
2. When the desired alarm is displayed, press and hold the 'ALARM' button until the hour digits flash.
3. Use the '+' or '-' buttons to adjust the hour. Press 'ALARM' again to confirm the hour and move to minutes.
4. Use the '+' or '-' buttons to adjust the minutes. Press 'ALARM' again to confirm.
5. You may also be able to set the alarm to activate on specific days (e.g., weekdays, weekends, or daily). Follow on-screen prompts or refer to the button functions.
6. To activate/deactivate an alarm, press the 'ALARM' button briefly when the alarm time is displayed. An alarm icon will appear/disappear on the screen.

3. Funkcija dremeža

When an alarm sounds, press the 'SNOOZE/LIGHT' button located on the top of the clock. The alarm will pause for approximately 5 minutes and then sound again. This can typically be repeated multiple times.

4. Aktivacija osvetlitve ozadja

To illuminate the display, press the 'SNOOZE/LIGHT' button on the top of the clock. The backlight will activate for a few seconds, providing visibility in low-light conditions.

Image: Front display of the alarm clock with the backlight activated, showing the time (13:43), date (25/4), and day of the week (MON) with enhanced visibility.

5. Prikaz datuma in dneva v tednu

The clock automatically displays the current date and day of the week once synchronized with the radio signal. No manual adjustment is typically required for these features.

Vzdrževanje

1. Čiščenje

Wipe the clock with a soft, dry cloth. Do not use abrasive cleaners or solvents, as these can damage the casing ali zaslon.

2. Zamenjava baterije

When the display dims or the clock functions become erratic, it is time to replace the batteries. Follow the battery installation steps outlined in the 'Setup' section.

Odpravljanje težav

• No Display / Clock Not Functioning: Ensure batteries are inserted correctly with proper polarity. Replace old batteries with new ones.
• Incorrect Time / No Radio Signal: Move the clock to a location with better radio signal reception, away from electronic interference. Allow several hours for synchronization. Manual time setting may be required if the signal is consistently weak.
• Alarm se ne oglasi: Verify that the alarm is activated (alarm icon visible on display) and that the alarm time is set correctly.
• Snooze Not Working: Ensure you are pressing the correct 'SNOOZE/LIGHT' button when the alarm is active.

Specifikacije

Garancija in podpora

For warranty information or technical support, please refer to the retailer where the product was purchased or visit the official Atlanta brand webspletnega mesta. Prosimo, shranite dokazilo o nakupu za morebitne garancijske zahtevke.