Behringer DI800 V2 Signal Direct Box Instruction Manual

1. Uvod

The Behringer DI800 V2 is a professional 8-channel direct injection (DI) box designed to connect instruments or other audio sources directly to a mixing console or amplifier. It converts unbalanced, high-impedance signals into balanced, low-impedance signals, suitable for long cable runs without signal degradation. The DI800 V2 offers flexible power options, including mains power or phantom power from a mixing console, and features an ultra-flat frequency response for transparent audio reproduction.

2. Pomembna varnostna navodila

• Pred uporabo naprave natančno preberite ta navodila.
• Ta navodila shranite za prihodnjo uporabo.
• Upoštevajte vsa opozorila na izdelku in v priročniku.
• Te naprave ne uporabljajte v bližini vode ali vlage.
• Čistite samo s suho krpo.
• Ne blokirajte prezračevalnih odprtin. Namestite v skladu z navodili proizvajalca.
• Ne nameščajte v bližini virov toplote, kot so radiatorji, grelniki, peči ali druge naprave (vključno z amplifiers), ki proizvajajo toploto.
• Ne izničite varnostnega namena polariziranega ali ozemljenega vtiča. Polarizirani vtič ima dve rezili, od katerih je ena širša od druge. Ozemljeni vtič ima dve rezili in tretji ozemljitveni vtič. Široko rezilo ali tretji zatič sta na voljo za vašo varnost. Če priloženi vtič ne ustreza vaši vtičnici, se obrnite na električarja za zamenjavo zastarele vtičnice.
• Zaščitite napajalni kabel, da se po njem ne pohodi ali stisne, zlasti pri vtičih, vtičnicah in na mestu, kjer izstopa iz naprave.
• Uporabljajte samo priključke/dodatke, ki jih je določil proizvajalec.
• Izklopite napravo med nevihtami ali ko je dlje časa ne uporabljate.
• Za vse servise se obrnite na usposobljeno servisno osebje. Servis je potreben, če je bil aparat kakor koli poškodovan, na primer poškodovan je napajalni kabel ali vtič, je bila polita tekočina ali so v aparat padli predmeti, je bil aparat izpostavljen dežju ali vlagi, ne deluje normalno , ali je bil opuščen.

3. Razpakiranje in prvi pregled

Upon receiving your Behringer DI800 V2, carefully unpack the unit and inspect it for any signs of damage that may have occurred during transit. If damage is found, contact your dealer immediately. The package should contain the DI800 V2 unit and a power cable. Ensure all components are present before proceeding with setup.

4. Nastavitev

4.1 Prekrivanje sprednje ploščeview

Slika 1: Front panel of the Behringer DI800 V2. Each of the 8 channels features an input jack, a link output, a -20dB pad switch, and a ground lift switch. LED indicators show signal presence and phantom power status.

• INPUT (1-8): 1/4" TS/TRS input jacks for connecting instruments or line-level sources.
• LINK (1-8): 1/4" TS/TRS output jacks for connecting the input signal to an amplifier or monitor. This output is parallel to the input.
• -20dB PAD (1-8): Attenuates the input signal by 20dB. Use this for high-output sources to prevent clipping.
• GROUND LIFT (1-8): Disconnects the ground connection between the input and output, which can help eliminate hum or ground loops.
• Stikalo za vklop: Vklopi ali izklopi enoto.
• PHANTOM POWER LED: Illuminates when phantom power is detected on an XLR output.
• LED SIGNAL: Sveti, ko je prisoten vhodni signal.

4.2 Zadnja plošča čezview

Slika 2: Rear panel of the Behringer DI800 V2. It features eight balanced XLR outputs and the AC power input.

• BAL OUT (1-8): Balanced XLR outputs for connecting to a mixing console's microphone inputs.
• AC VHOD: Standard IEC power connector for connecting the included power cable.

4.3 Napajanje enote

The DI800 V2 can be powered in two ways:

1. Omrežna moč: Connect the supplied AC power cable to the AC INPUT on the rear panel and then to a suitable wall outlet.
2. Fantomska moč: The unit can also be powered by 48V phantom power supplied from a mixing console via the XLR outputs. If phantom power is present on at least one XLR output, the unit will power on automatically. The PHANTOM POWER LED on the front panel will illuminate.

Opomba: If both mains power and phantom power are connected, the unit will prioritize mains power. It is recommended to use mains power for consistent operation, especially if phantom power sources are unreliable or vary.

4.4 Povezave

• Connect your instrument (e.g., guitar, bass, keyboard) to an VNOS jack on the front panel using a 1/4" TS or TRS cable.
• If you need to send the signal to an amplifier or monitor on stage, connect a 1/4" TS or TRS cable from the corresponding POVEZAVA priključek na tvoje ampprispevek uporabnika za življenje.
• Povežite BAL VEN XLR output on the rear panel to a microphone input on your mixing console using a balanced XLR cable.

5. Navodila za uporabo

5.1 Pretok signala

The DI800 V2 takes an unbalanced, high-impedance signal from your instrument, converts it to a balanced, low-impedance signal, and sends it to your mixing console. The LINK output provides a direct, unprocessed copy of the input signal for local monitoring.

5.2 Using the -20dB Pad

If your instrument or audio source has a very high output level, the input signal to the DI800 V2 might be too strong, leading to distortion. In such cases, engage the -20dB PAD switch for the corresponding channel. This will reduce the input signal level by 20 decibels, preventing clipping and ensuring a clean signal to the mixing console.

5.3 Ground Lift Function

Ground loops can cause an audible hum or buzz in your audio system. The GROUND Dvigalo switch disconnects the ground connection between the input and output stages of the DI800 V2. If you experience hum, try engaging the GROUND LIFT switch for the affected channel. This often resolves ground loop issues without affecting the audio signal.

5.4 Monitoring Signal Presence

The LED SIGNALA for each channel illuminates when an audio signal is detected at the input. This provides a quick visual confirmation that your instrument is connected and sending a signal to the DI box.

6. Vzdrževanje

• Čiščenje: Pred čiščenjem enoto izključite iz električnega omrežja. Za brisanje zunanjosti uporabite mehko, suho krpo. Ne uporabljajte tekočih čistil ali topil.
• Shranjevanje: Store the DI800 V2 in a cool, dry place away from direct sunlight and extreme temperatures.
• storitev: There are no user-serviceable parts inside the DI800 V2. Refer all servicing to qualified service personnel.

7. Odpravljanje težav

8. Specifikacije

9. Garancija

Za podrobne informacije o garanciji se obrnite na uradno spletno stran podjetja Behringer. website or contact Music Tribe US support. The warranty typically covers manufacturing defects for a specified period from the date of purchase. Keep your proof of purchase for warranty claims.

Opis garancije: Musictribe. Support.

10. Podpora

If you encounter issues not covered in this manual or require further assistance, please visit the official Behringer support website or contact Music Tribe US customer service. You can find contact details and additional resources on their official webmesto.

Spletna podpora: Music Tribe Support