Trelock LS 812 Trio Flat Battery-Powered Bicycle Taillight User Manual

Uvod

Welcome to the user manual for your Trelock LS 812 Trio Flat battery-powered bicycle taillight. This light is designed to enhance your visibility and safety on the road. Please read these instructions carefully before installation and use to ensure optimal performance and longevity of your product.

Varnostne informacije

• Always ensure the taillight is securely mounted before riding.
• Do not look directly into the light source to avoid eye injury.
• Baterije hranite izven dosega otrok.
• Ne mešajte starih in novih baterij ali različnih vrst baterij.
• Izrabljene baterije zavrzite v skladu z lokalnimi predpisi.
• This product is approved according to StVZO (German Road Traffic Licensing Regulations) for use on bicycles.

Vsebina paketa

• Trelock LS 812 Trio Flat Bicycle Taillight
• 2 baterije AA 1.5 V
• Mounting Hardware (2 screws, 2 nuts)

Nastavitev

Namestitev baterije

The Trelock LS 812 Trio Flat requires two AA 1.5V batteries.

1. Locate the small screw on the side of the taillight, near the on/off switch.
2. Use a small hex key (not included) to loosen this screw.
3. Carefully separate the transparent plastic housing from the black mounting plate to access the battery compartment.
4. Vstavite dve bateriji AA in pazite na pravilno polarnost (+/-).
5. Reattach the transparent housing to the mounting plate and tighten the screw.

Opis slike: Bližnji posnetek view of the Trelock LS 812 Trio Flat taillight, showing the black on/off switch and the small screw used to open the battery compartment.

Montaža zadnje luči

The LS 812 Trio Flat is designed for carrier mounting.

1. Position the taillight on your bicycle's rear carrier, aligning the mounting holes.
2. Insert the provided screws through the taillight and carrier holes.
3. Secure the taillight by tightening the nuts onto the screws from the other side of the carrier.
4. Prepričajte se, da je luč trdno pritrjena in usmerjena neposredno nazaj.

Image description: The rear view of the Trelock LS 812 Trio Flat taillight, showing the two mounting bolts and nuts for attachment to a bicycle carrier.

Navodila za uporabo

Vklop/izklop

To turn the taillight on or off, press the black switch located on the front of the light.

Image description: The front view of the Trelock LS 812 Trio Flat taillight, highlighting the central black on/off switch.

Indikator napolnjenosti baterije

The taillight features a battery level indicator. When the battery power is low, the indicator will signal that it's time to replace the batteries.

Vzdrževanje

Čiščenje

Clean the taillight regularly with a soft, damp cloth. Do not use abrasive cleaners or solvents, as these can damage the housing or lens.

Zamenjava baterije

When the battery level indicator signals low power, replace both AA batteries following the "Battery Installation" steps. Always replace both batteries at the same time with new ones of the same type.

Shranjevanje

If the taillight will not be used for an extended period, remove the batteries to prevent leakage and potential damage to the device.

Odpravljanje težav

Lučka se ne prižge

• Preverite, ali so baterije pravilno vstavljene s pravilno polarnostjo.
• Zamenjajte baterije z novimi.
• Ensure the battery compartment screw is tightened.

Svetloba je zatemnjena

• Replace the batteries with new ones. Dim light is often an indication of low battery power.

Specifikacije

Image description: A visual representation of the Trelock LS 812 Trio Flat taillight held in a hand, illustrating its compact dimensions of approximately 8 cm length, 5 cm width, and 5 cm height.

Garancija

This product is covered by a warranty in accordance with statutory provisions. Please retain your proof of purchase for any warranty claims.

Podpora

For further assistance, technical support, or inquiries not covered in this manual, please contact your retailer or the manufacturer, Trelock.