MXR® Distortion+ Instruction Manual

1. Uvod

The MXR Distortion+ is a classic guitar effects pedal known for its distinctive distortion sounds. This compact unit is designed to deliver a range of tones from subtle overdrive to classic hard rock distortion. Its germanium-powered, soft-clipped distortion circuit has been a staple on countless recordings, offering a unique sonic character.

Ključne značilnosti:

• Germanium-powered, soft-clipped distortion
• Classic 70s distortion
• Classic early ’80s hard rock tone
• Kompakten in trpežen dizajn

2. Nastavitev

Before connecting your MXR Distortion+ pedal, ensure your amplifier is turned off. This prevents any potential damage to your equipment.

Povezave:

1. Priključite svojo kitaro na VNOS vtičnico na desni strani pedala s standardnim 6,3 mm kablom za instrument.
2. Povežite IZHOD dvigalko na levi strani pedala na vaš amplifier's input using another 1/4-inch instrument cable.

Napajanje pedala:

The MXR Distortion+ can be powered by a 9V battery or an optional 9V DC power adapter (center negative).

• Namestitev baterije: To install a 9V battery, remove the bottom plate of the pedal by unscrewing the four screws. Connect the battery to the clip and place it inside the enclosure before reattaching the bottom plate.
• Napajalnik: Connect a 9V DC power adapter (not included) to the power jack on the side of the pedal.

Slika: Stran view of the MXR Distortion+ pedal, highlighting the input, output, and 9V power jacks.

Slika: Spodaj view of the MXR Distortion+ pedal, showing the four screws that secure the battery compartment.

3. Kontrole

The MXR Distortion+ features two primary control knobs and a footswitch for activation.

Slika: Zgoraj view of the MXR Distortion+ pedal, clearly showing the 'Output' and 'Distortion' control knobs.

• IZHOD: This knob controls the overall output volume of the effect. Turn clockwise to increase volume, counter-clockwise to decrease.
• POPAČENJE: This knob adjusts the amount of distortion applied to your signal. Turn clockwise for more distortion, counter-clockwise for less.
• NOŽNO STIKALO: Toggles the effect on/off. The LED illuminates when the effect is active.

4. Delovanje

The MXR Distortion+ is straightforward to operate, allowing you to quickly dial in a variety of distorted tones.

• Classic Blues Tones: Set the DISTORTION control low (e.g., 9 o'clock to 12 o'clock) and adjust the OUTPUT knob to drive the front end of your amplifier. This will produce a warm, overdriven blues tone.
• Early '80s Hard Rock: Max out the DISTORTION knob (e.g., 3 o'clock to full clockwise) for a powerful, saturated hard rock tone. Adjust OUTPUT to match your desired volume.
• Subtle Boost/Overdrive: For a cleaner boost with a touch of grit, set DISTORTION very low and OUTPUT to unity gain or slightly above.

Demonstration Videos (for related MXR pedals):

5. Specifikacije

6. Vzdrževanje

• Čiščenje: Use a soft, dry cloth to clean the pedal. Avoid abrasive cleaners or solvents.
• Shranjevanje: Pedal shranjujte v suhem okolju, stran od ekstremnih temperatur in neposredne sončne svetlobe.
• Življenjska doba baterije: If using a battery, disconnect the input cable when not in use to conserve battery life. Remove the battery if the pedal will not be used for an extended period.

7. Odpravljanje težav

• Ni zvoka:
  • Check all cable connections (guitar to input, output to amp).
  • Ensure the pedal is receiving power (check battery or power adapter).
  • Preverite svojo kitaro in ampživljenjska doba deluje pravilno.
• Šibek ali popačen zvok (nepričakovano):
  • Replace the 9V battery if it's low.
  • Ensure the power adapter meets the 9V DC (center negative) specification.
  • Adjust the OUTPUT and DISTORTION knobs to find your desired tone.

8. Garancija in podpora

This product is covered by the manufacturer's warranty. For detailed warranty information or technical support, please refer to the official MXR webspletno mesto ali se obrnite neposredno na njihovo službo za stranke. Shranite dokazilo o nakupu za uveljavljanje garancije.